Adjusting The Direction Of Air Circulation - Friedrich MW24Y3F Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ADJUSTING THE DIRECTION OF AIR CIRCULATION

G Adjust the up, down, left, and right AIR directions with the AIR DIRECTION buttons on the Remote Control Unit.
G Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the airflow-direction louvers have
stopped moving.
Vertical Air Direction Adjustment
Press the SET button (Vertical) (Fig. 6 R).
Each time the button is pressed, the air direction range will change as follows:
1
Types of Air flow Direction Setting:
1,2,3 :
During Cooling/Dry modes
4,5,6 :
During Heating mode
The Remote Control Unit's display does
not change.
G Use the air direction adjustments within the ranges shown above.
G The vertical airflow direction is set automatically as shown, in accordance with
the type of operation selected.
During Cooling/Dry mode : Horizontal flow 1
During Heating mode
G During AUTO mode operation, for the first minute after beginning operation,
airflow will be horizontal 1; the air direction cannot be adjusted during this pe-
riod.
G Direction 1
2
Only the direction of the Air Flow Direction Louver changes; the direction of the
Power Diffuser does not change.
Horizontal Air Direction Adjustment
Press the SET button (Horizontal)(Fig. 6 S).
G Each time the button is pressed, the air direction range will change as follows:
1
2
The remote control unit's
display does not change.
1
En-9
2
3
4
5
1
2
3
4
5
6
: Downward flow 5
3
4
5
2
5
3
4
R DANGER!
G Never place fingers or foreign objects in-
side the outlet ports, since the internal fan
operates at high speed and could cause
personal injury.
6
G Always use the Remote Control Unit's
SET button to adjust the vertical airflow
louvers. Attempting to move them
manually could result in improper op-
eration; in this case, stop operation and
restart. The louvers should begin to
operate properly again.
G During use of the Cooling and Dry
modes, do not set the Air Flow Direc-
tion Louvers in the Heating range (4 -
6
ter vapor may condense near the out-
let louvers and drops of water may drip
from the air conditioner. During the
Cooling and Dry modes, if the Air Flow
Direction Louvers are left in the heat-
ing range for more than 30 minutes,
they will automatically return to posi-
tion 3.
G When used in a room with infants, chil-
dren, elderly or sick persons, the air
direction and room temperature
should be considered carefully when
making settings.
) for long periods of time, since wa-

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mr24y3f

Table des Matières