Install Trim Kit Frame - Whirlpool MK2167 Instructions D'installation

1. Position trim kit frame over the opening so that the lower tabs
rest on the cutout floor, as shown.
A
A. Front of trim kit frame
B. Tabs (upper and lower)
C. Cutout/cabinet floor
2. Holding the trim kit frame in place, use 7/64" drill to drill four
pilot holes into the front facing of the cutout/cabinet through
the mounting hole guides in the upper and lower corners of
the trim kit frame.
NOTES:
The holes will be drilled downward from the top, and
upward from the bottom at an angle of about 45°.
To avoid damage to the trim kit frame, do not overtighten
screws.
A B
A. Trim kit frame
B. Mounting hole guide
6

Install Trim Kit Frame

B
C
C
D
C. Long wood screw (4 - painted)
D. Cutout ceiling
3. Secure trim kit frame to cutout/cabinet by installing four long
wood screws (painted) into the pilot holes drilled in Step 2
above.
Installation is now complete. Replace any loose items that have
been removed from microwave oven cavity.
Save these Installation Instructions for future reference.