Prepare Cutout/Cabinet Opening - Whirlpool MK2167 Instructions D'installation

1. On the cutout floor, find and mark the centerline.
2. Place the bottom duct in the opening, with the flange resting
against the bottom front facing of the opening.
A
D
A. Cutout floor
B. Centerline
C. Bottom duct
3. Align the center arrows on the bottom duct with the centerline
drawn in Step 1 above.
A
A. Bottom duct
B. Center arrows, aligned with centerline
4

Prepare Cutout/Cabinet Opening

B C
E
D. Bottom duct flange
E. Front facing
B
4. Mark the three mounting holes through the bottom duct onto
the cutout floor.
A
A. Short screws (3)
B. Bottom duct mounting holes
5. Using 7/64" drill, drill pilot holes into the three holes marked in
Step 4.
6. Realign and install the bottom duct with three short screws.
7. Using 7/64" drill, drill pilot holes through the four mounting
holes of the bottom duct flange into the bottom front facing of
the cutout/cabinet opening.
A
A. Bottom duct flange
B. Mounting holes
B
B