Prepare Cutout/Cabinet Opening - Whirlpool MKC2157 Instructions D'installation

3. Slide two tabs into the slots on the right side of the back of
microwave oven.
A
A. Rear duct tabs
B. Slots
4. Use two short screws to secure top of rear duct to the back of
microwave oven, as shown.
A
A. Short screws (2)
B. Rear duct
C. Back of microwave oven
5. Use three short screws to secure back of rear duct to the back
of microwave oven, as shown.
A
A. Short screws (3)
B. Rear duct
C. Back of microwave oven
4
B
B C
B C

Prepare Cutout/Cabinet Opening

1. On the cutout floor, find and mark the centerline.
2. Place the bottom duct in the opening, with the flange resting
against the bottom front facing of the opening.
A
D
A. Cutout floor
B. Centerline
C. Bottom duct
3. Align the center arrows on the bottom duct with the centerline
drawn in Step 1 above.
A
A. Bottom duct
B. Center arrows, aligned with centerline
B C
E
D. Bottom duct flange
E. Front facing
B