Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
■
Measuring tape
■
Pencil
■
Scissors
Parts Supplied
A
F
A. Trim kit frame
B. Side duct (1)
C. 1" screws (4, plus 2 extra)
D. 1/2" screws (15, plus 2 extra)
E. Anti-tip bracket (1)
Minimum Cutout Dimensions
A
³⁄₄
15
"
(40.0 cm)
3"
(7.6 cm)
2
INSTALLATION INSTRUCTIONS
■
#2 Phillips screwdriver
■
5/64" drill
B
C
D
G
H
F. Bottom duct (1)
G. Bottom bracket (1)
H. Upper duct (1)
I. Template
t h W
t h
i d
i d
W
B
A. Depth
B. Width
DIM.
OVER 24"
(61.0 CM)
BUILT-IN OVEN
Width
22¹⁄₂"
(57.15 cm)
Depth
18¹⁄₂" (46.99 cm) min. with flush mount receptacle;
19" (48.26 cm) min. without flush mount receptacle
Height 15³⁄₄" (40.01 cm) (for all models)
Trim Kit Frame Dimensions
E
¹⁄₄
18
"
(46.4 cm)
*For installation over 24" (61.0 cm) built-in oven
**For installation over 27" (68.6 cm) built-in oven
I
***For installation over 30" (76.2 cm) built-in oven
Electrical Requirements
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Observe all governing codes and ordinances.
Required:
■
A 120 Volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
OVER 27"
OVER 30"
(68.6 CM)
(76.2 CM)
BUILT-IN OVEN
BUILT-IN OVEN
25¹⁄₂"
25¹⁄₂"
(64.77 cm)
(64.77 cm) min.;
28¹⁄₂"
(72.39 cm) max.
¹⁄₁₆
12
"
(30.6 cm)
WARNING
Electrical Shock Hazard
¹³⁄₁₆
"
(2.1 cm)
Publicité
Table des Matières
