Install Oven - Whirlpool WOC54EC0AB Instructions D'installation

1. Using 2 or more people, lift oven partially into cabinet cutout.
Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside
edges.
2. Push against seal area of front frame to push oven completely
into cabinet and center oven into cabinet cutout.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
NOTE: If you have model KEMS308S, KEHU309S or
KEMS378S, proceed to Step 5.
4. Insert the grommet into the mounting rail hole using a flat-
blade screwdriver. Insert the screwdriver into the grommet
and turn ¹⁄₄ turn counterclockwise. Make sure the grommet
stays in position.
A
B
C
A. Mounting rail
B. Mounting rail hole
C. Grommet

Install Oven

5. Securely fasten oven to cabinet using the #8–14 x 1" screws
provided. Insert the screws through hole in the grommet. Do
not overtighten screws.
6. On some models, the oven vent is taped to the side of the
oven. See the following instructions to install.
Insert the vent tabs (B) into slots (A) in the oven frame.
With one #8–18 x ³⁄₈" screw (C) for each side of the vent,
fasten vent securely to the oven.
A
D
C
7. Replace oven racks.
8. Replace oven door by inserting ends of hinges into hinge
slots in the oven frame.
9. Push hinges in as far as they will go and open the oven door.
You should feel the oven door drop into place.
10. Rotate both hinge latches back to the locked position.
11. Check that door is free to open and close. If it is not, repeat
the removal and installation procedures. See "Prepare Built-In
Microwave/Oven Combination" section.
12. Reconnect power.
13. Display panel will light briefly, and "PF" should appear in the
display.
14. If display panel does not light, please reference the
"Assistance or Service" section of the Use and Care Guide or
contact the dealer from whom you purchased your oven.
B
A. Oven frame slot
B. Vent tab
C. #8–18 x ³⁄₈" screw
D. Oven vent
7