F.F. Group HPW 150i PLUS Notice Originale page 17

HPW 150i PLUS | HPW 160i PLUS
the trigger gun (M).
Push the nozzle forward to the position "low". De-
tergent flow is adjusting using the regulator (Q).
RECOMMENDED CLEANING METHOD
Spray the detergent sparingly on the dry surface and
f
allow it to react, but not to dry.
Push the nozzle back to the position high to remove
f
the detergent.
AFTER OPERATION WITH DETERGENT
Drain and wash out the detergent tank at the end
of the working session. To wash out the tank use
clean water instead of the detergent.
FINISH OPERATION
Release the lever of the trigger gun.
f
Turn off the appliance " ON/OFF".
f
Disconnect the mains plug from the socket.
f
Only separate the high-pressure hose from the trig-
ger gun or the device when there is no pressure in
the system.
ATTENTION!
Pressure the lever of the trigger gun to
ƒ
release any remaining pressure in the
system.
Release the lever of the trigger gun.
ƒ
Lock the lever of the trigger gun (N).
ƒ
Beware that when disconnecting the
ƒ
supply or high pressure hose, the hose is
filled with water.
Detach the appliance from the water sup-
ƒ
ply.
MAINTENANCE AND SERVICE
Stop, remove plug from the power supply and
disconnect from water supply.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose
fixings, and worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the replacement of the supply cord is necessary,
this has to be done by FF GROUP or an authorized
FF GROUP service agent in order to avoid a safety
hazard.
CLEAN THE WATER FILTER/NOZZLE REGULARLY
The water filter must not be damaged.
f
Pull the sieve out (O)
f
Clean the sieve under running water.
f
Reinsert the sieve into the water filter and assemble
f
the filter on the machine.
Clean the nozzle with the needle clean-out tool provid-
f
ed. Remove the spray lance from the gun. Remove any
dirt from the nozzle hole and rinse (P).
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
as waste. Machine, accessories and pack-
aging should be sorted for environment -
friendly recycling. The plastic components
are labeled for categorized recycling.
GUARANTEE
This product is warranted in accordance with the le-
gal/country specific regulations, effective from the
date of purchase by the first user. Damage attribut-
able to normal wear and tear, overload or improper
handling will be excluded from the guarantee. In
case of a claim, please send the machine, completely
assembled, to your dealer or the service Centre for
electric power tools.
English | 17
www.ffgroup-tools.com