Avintage AVI60PREMIUM Manuel D'utilisation page 42

5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
12°C/12-20°C.
Temperature setting
A ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
B Decrease temperature of 1 degree Celsius or Fahrenheit.
C Raise temperature of 1 degree Celsius or Fahrenheit.
Display shows upper zone temperature at its setting.
D
E Temperature display in Celsius.
F Temperature display in Fahrenheit.
Display shows lower zone temperature at its setting.
G
Compartment selecting switch (lower or upper one). Once the compartment has been
selected, it will show setting temperature as flash, 5 seconds later flash will stop and setting
H
temperature will be showing
Alarm cancel switch, press once to cancel the alarm. Press and hold 5 seconds to change
I
Celsius or Fahrenheit.
J Light ON/OFF switch, turn on and turn off the light.
Temperature selection
The wine cooler has two temperature zones. The temperature setting of upper zone is adjustable with the
range 5-12°C, which is ideal for storing sparkling and white wines. The temperature setting of lower zone
is adjustable with the range 12-20°C, which is ideal for storing white and red wines.
NOTE: both two zones temperature could be set at 12ºC, and it is workable at the same time. But
for optimal performance, once one zone is set at 12ºC, we suggest another setting for the other
zone with 3°C difference at minimum (example: 5°C upper and 8°C lower). Maximum temperature
difference between both compartments is 10°C. Always set cooler temperature in the upper
compartment and warmer temperature in the lower compartment (example: 5°C upper and 15°C
lower).
 To select the temperature zone, press (H) once, upper zone will flash, (H) key pressing again to
switch it to lower zone. Setting temperature could only be set under display flash status.
 You can touch key "+" (C) and key "-" (B) to set the internal temperature for the selected zone. The
degrees indicators will appear in the display window marked
 When the unit is plugged in for the first time, the LED readouts will show the original temperature set
for upper zone and for lower zone.
42