Connections - OK. ODL 32652F-TIB Mode D'emploi

Connections

Connector Type
Scart
Connection
(back)
VGA
Connection
(back)
SIDE AV
PC/YPbPr
Audio
Connection
(side)
HDMI
Connection
(back)
SPDIF
SPDIF
(Coaxial Out)
Connection
(back)
SIDE AV
Side AV
(Audio/Video)
Connection
(side)
HEADPHONE
Headphone
Connection
(side)
YPBPR YPbPr Video
Connection
(back)
USB
Connection
(side)
CI
Connection
(side)
LAN
Ethernet
Connection
(back)
If you want to connect a device to the TV, make sure that both the TV and the device are turned off before making
any connection. After the connection is done, you can turn on the units and use them.
Cables
YPbPr/PC Audio Cable
AV Cable
PC to YPbPr Connection Cable
LAN / Ethernet Cable
English - 40 -
See the illustrations on the left
Device
side. You can use YPbPr to VGA
cable to enable YPbPr signal via
VGA input. You cannot use VGA
and YPbPr at the same time.
To enable PC/YPbPr audio, you
will need to use the side audio
inputs with a YPbPr/PC audio
cable for audio connection. If
an external device is connected
via the SCART socket, the TV
will automatically switch to EXT1
mode. When receiving DTV
channels (Mpeg4 H.264) or while
in Media Browser mode, output
will not be available via the scart
socket. When using the wall
mounting kit (available from
a third party in the market, if
not supplied), we recommend
that you plug all your cables
into the back of the TV before
mounting on the wall. Insert
or remove the CI module only
when the TV is SWITCHED OFF.
You should refer to the module
instruction manual for details of
the settings. The/Each USB input
of your TV supports devices up
to 500mA. Connecting devices
that have current value above
500mA may damage your TV.
When connecting equipment
using a HDMI cable to your TV,
to guarantee sufficient immunity
against parasitic frequency
radiation, you have to use a high
speed shielded (high grade) HDMI
cable with ferrites.