Jet JCDC-3.0-T Instructions De Fonctionnement page 12

17. Install hose (J) onto cone and drum lid and secure
with two hose clamps (K) at top and bottom. See
Figure 12.
Figure 12
The bag frame maintains the shape of the bag in the
negative-pressure environment of the cyclone drum.
Assemble bag frame as follows:
18. Screw the short and long frame supports into the
hoops in alternating manner, as shown in Figure
13. Secure with 24 pan head screws and hex nuts
(HP11,HP12). (Note: The bends on long supports
point inward as shown.)
Figure 13
19. Place drum collection bag (Q) into drum with its
top edge wrapped around top edge of drum.
Place bag frame (S) inside bag and press all the
way down. See Figure 14.
20. Pull down both quick levers (R, Figure 12) then
assemble drum lid (H, Figure 12) to quick levers.
Tighten long nut (R , Figure 12) onto each quick
1
lever.
21. Raise drum lid using quick levers, and position
drum beneath lid. Lower quick levers to secure lid
upon drum.
12
Figure 14