Bartscher K7EBM05VV Mode D'emploi page 24

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Vat Filling (fig.7 – pag.4)
First of all ensure that the drain tap is tightly closed, having done this turn the water load knob
anticlockwise (1), fill the vat to the marked level.
Bain maries (fig. 6 – pag.4)
To heat a bain maries vat, proceed in the following way:
-
Turn the thermostat knob (1) to the position of the required heating temperature;
-
Push the button (2). Inside of it a green lamp remains always lighted to indicate the presence of
the tension. At the same time the warning lamp lights (3): the orange lamp turns off when the
temperature in the tank is reached.
-
For switching off, push the button (2).
Vat Draining (fig. 8 – pag.4)
To drain the vat it is necessary to turn the lever on the control panel (1) anticlockwise.
At the time of draining, make sure that the appliance is not working.
ATTENTION! Only use the appliance under surveillance. Never heat up an empty vat.
Abnormal functioning
If for any reason, the appliance does not start or stops working during use, check that the energy
supply and the control knobs are set correctly; if all is regular, call customer service.
CARE AND MAINTENANCE OF THE APPLIANCE
Cleaning
ATTENTION! Before doing any cleaning, make sure that the appliance is disconnected from
the electric mains. During cleaning operations, avoid using direct or high pressure sprays of
water on the appliance. Cleaning must be done when the appliance is cold.
The parts in steel can be cleaned with warm water and neutral detergent, using a cloth; the detergent
must be suitable for cleaning stainless steel and must not contain abrasive or corrosive substances.
Do not use common steel wool or anything similar which, depositing iron particles, could cause rust
from it. It is also better to avoid using sandpaper or emery paper. Only in the event of encrusted dirt,
pumice stone in powder may be used but an abrasive synthetic sponge or stainless steel wool would
be preferable, to be used in the direction of the grain. After washing, dry with a soft cloth.
If the appliance is out of use for a long time, it is advisable to disconnect the main electricity supply
and wipe all stainless steel surfaces with a cloth soaked in vaseline oil in order to give it a protective
film and air the rooms now and again.
INSTRUCTIONS FOR USE
Pag. 23/40

Publicité

Table des Matières
loading

Table des Matières