Description Of The Hood; Control - Elica Professional Série Guide D'utilisation, D'entretien Et D'installation

Description of the hood

5
2
1
1.
Blower and light controls
2.
LED lamps
3.
Grease filter
4. Grease filter handle
5.
Duct covers

Control

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen. The hood controls are located on the center
side of the range hood.
Recessing Knobs
• You can hide control knobs by depressing them until flush
with the hood body.
4
• Pressing the knobs again will lower the knobs, and enable
3
the user to operate the lights and blower.
Controls
Operating the lamps
1. Turn the light switch to the "ON" position to turn the
range hood lights On.
2. Turn the light switch to the "OFF" position to turn the
range hood lights Off.
Operating the blower
1. Turn the blower switch at "1" to turn the range hood on.
2. Turn the blower switch to the desired speed position.
3. Turn the blower switch to the "MAX" position to turn the
range hood on High.
4. Turn the blower switch to the "OFF" position to turn the
range hood blower Off.
Auto On blower
The range hood is equipped with a sensor to automatically turn
on the blower when excessive heat is detected in the control
area. When the blower switch is in the "Off" position, this sensor
will turn the blower to high speed when necessary. When the
heat decreases, the blower will turn off. When the blower
switch is in the On position, the heat sensor is not active and
the range hood functions normally.
B
A
A. Lamps knob B. Blower knob
11