Ice Device System - Efco MT 3500S Manuel D'utilisation Et D'entretien

en
22
OPERATION
• Pull the starter rope to start the engine (5, Fig. 52A).
• Once the engine is going release the chain brake and wait for
a few seconds. Place chain brake lever / hand guard into the
run position as shown in Fig. 46A. Refer to Safety-Chain Brake
and Operation-Chain
information.
• Then accelerate with the throttle (B, Fig. 49) to fire the half
throttle-blocking device.
WARNING: Do not cut material with the choke/fast
47
idle lever at the FULL CHOKE position. Do not
operate your chainsaw with the starting throttle lock
engaged. Cutting with the starting throttle lock
engaged does not permit the operator proper control
of the saw or chain speed.
NOTE - STARTING WARM ENGINE:
Follow above starting instructions, but do not use the Full
Choke position for start up again. To set fast idle for warm
engine starting, pull choke out completely and push back in
to the original Run Position.
48
WARNING: Weather conditions and altitude may
affect carburetion. Do not allow bystanders close to
the chain saw while adjusting the carburetor.
WARNING: Never attempt to start the chainsaw
when the guide bar is in a cut or kerf.
WARNING: Never start the saw engine without the
bar, chain and clutch cover (chain brake) assembled
- or else the clutch can come loose and cause
49
personal injuries.
49A

Ice Device System

In the event of temperatures below 0°C, move the cursor
(A, Fig. 49A) to the winter position. In this way heated air from the
cylinder is also taken in, preventing thus the formation of ice
inside the carburettor.
When the temperature rises above +10°C, move the cursor
(A, Fig. 49 B) to the summer position. Failure to reset this
parameter could impair motor performance due to
overheating.
49B
Brake Sections for additional