Setting-Up The Projector; Positioning The Projector; Adjustable Feet - Eiki LC-NB2W Mode D'emploi

SETTING-UP THE PROJECTOR

This projector is basically designed to project on a flat projection surface.
The projector can be focused from 1.4m ~ 10.8m.
Refer to the figure below to adjust the screen size.
30"
Screen Size
(W x H) mm
610 x 457
Height (H1)
435mm
Height (H2) 22mm
ROOM LIGHT
The brightness in the room has a great influence on the picture quality. It is recommended to limit ambient
lighting in order to provide the best image.
Picture tilt and projection angle can be adjusted by
rotating the ADJUSTABLE FEET. Projection angle can
be adjusted to 10 degrees.
Lift the front of the projector and pull the FEET LOCK
1
LATCHES on both sides of the projector.
Release the FEET LOCK LATCHES to lock the
2
ADJUSTABLE FEET and rotate the ADJUSTABLE
FEET for fine tune of the position and the tilt.
3 To shorten the ADJUSTABLE FEET, lift the front of the
projector and pull and undo the FEET LOCK LATCHES.
The position and the keystone distortion of the image
can be also adjusted with the Menu Operation. (Refer
to P 20, 28 and 29.)

POSITIONING THE PROJECTOR

3.6m
1.4m
100"
40"
77"
30"
60" 100"
1219 x 914 2032 x 1524
870mm 1451mm
44mm 73mm

ADJUSTABLE FEET

7.3m
5.5m
200"
150"
154"
115"
150" 200"
3048 x 2286 4064 x 3048
2177mm 2903mm
109mm 145mm
ADJUSTABLE FEET
10.8m
300"
231"
H1
H2
300"
6096 x 4572
4354mm
218mm
GB
FEET LOCK
LATCHES
7