Table des Matières
Publicité
5.0 AT Command Line Interface
La description
Obtenir / set règles de redirection de port du pare-feu
Syntaxe de la commande
AT+MFPORTFWD[=<Name>[,<Operation>[,<Source>,<Internal IP>,<Internal Port>,<Protocol>,<External Port>]]]
Paramètres
Name: Name of Port Forwarding rule, 1 - 64 characters
Operation: ADD - Add a rule
Source: 0 - WAN
Internal IP: Valid IP address
Internal Port: Valid port number, 1 - 65535
Protocol: 0 - TCP
External Port : Valid port number, 1 - 65535
Usage:
AT+MFPORTFWD
AT+MFPORTFWD=<Name>
AT+MFPORTFWD=<Name>,DEL
AT+MFPORTFWD=<Name>,ADD,<Source>,<Internal IP>,<Internal Port>,<Protocol>,<External Port>
AT+MFPORTFWD=<Name>,EDIT,<Source>,<Internal IP>,<Internal Port>,<Protocol>,<External Port>
Exemple
Commander:
AT+MFPORTFWD=rule1,add,0,192.168.168.203,20001,0,20001<enter>
Réponse:
OK
Commander:
AT+MFPORTFWD?
Réponse:
Name
Source
Internal IP : 192.168.168.203
Internat Port : 20001
Prorocol
External Port : 20001
OK
© Microhard 2016
EDIT - Edit a rule
DEL - Delete a rule
1 - Carrier
2 - WIFI
1 - UDP
2 - TCPUDP
: rule1
: WAN
: TCP
AT+MFDMZ
182
Publicité
Table des Matières
