Table des Matières
Publicité
5.0 AT Command Line Interface
La description
Afficher / Ajouter / Modifier / Supprimer l'interface WAN du réseau.
Syntaxe de la commande(Effet: AT&W)
AT+MNWAN[=<Mode>[,<Protocol>[,<IP>,<Netmask>[,<Gateway>]]]]
Usage:
AT+MNWAN
AT+MNWAN=<Mode>,<Protocol>,<IP>,<Netmask>[,<Gateway>] Where <Mode>=0/2 and <Protocol>=0
AT+MNWAN=<Mode>,<Protocol>
AT+MNWAN=<Mode>,<Protocol>
AT+MNWAN=<Mode>
Parameters:
Mode: 0 - Independent WAN
Protocol: 0 - Static IP
IP: Valid IP address
Netmask: Valid netmask
Gateway: Valid IP address. 0 - Reset
Exemple
Commander:
AT+MNWAN=0,1<enter>
Réponse:
OK
Commander:
AT+MNWAN?
Réponse:
Working Mode: Independent WAN
WAN Configuration
Default Route: Yes
DNS Server Mode: auto
OK
© Microhard 2016
1 - Bridge with LAN Port
2 - Independent LAN
1 - DHCP
2 - None
Connection Type: DHCP
Where <Mode>=0/2 and <Protocol>=1
Where <Mode>=2 and <Protocol>=2
Where <Mode>=1
AT+MNWAN
174
Publicité
Table des Matières
