Insignia NS-27RTV Guide De L'utilisateur page 8

NS-27RTV 27-inch Color TV
Selecting the video input source
Press TV/AV to view a signal from another
device connected to your television, such as a
VCR or DVD player. You can select ANT,
VIDEO1, VIDEO2 (on the front panel), or
COMPONENT depending on which input jacks
you used to connect your devices.
Pressing TV/AV on the remote control displays
the current signal source (press TV/AV again or
0-3 to change).
Connecting the television to a VCR
To Audio/
Video OUT
Audio/
Video
cord (not
supplied)
To Audio/
Video IN
Connecting the television to a VCR with an S-Video
cord
If you connect a VCR with a S-VIDEO cord to
the S-VIDEO IN jack on the rear of the television,
you must also connect the audio cords to the
AUDIO IN jacks on the rear of the television. The
S-VIDEO cord only carries the video signal. The
audio signal is separate.
To S-Video
OUT
Audio cord
S-Video
(not supplied)
cord (not
supplied)
To Audio
IN
To S-Video
IN
To Audio
OUT
Rear of the TV
Note
Connecting the television to a DVD player or
satellite receiver
If your DVD player or satellite receiver has an
S-Video out jack, connect cords as shown.
To S-Video
OUT
S-Video
cord (not
supplied)
To S-Video IN
Connecting the television to a DVD player with
component video
If your DVD player has component video out
jacks, connect your television to a DVD player
using a component video cord. It can greatly
enhance picture quality and performance.
To Audio
OUT
Audio
cord (not
supplied)
To COMPONENT
IN
Note
www.insignia-products.com
When the S-video cord and the video cord
are connected to each jack at the same time,
the S-video cord takes precedence over the
video cord.
To Audio
OUT
Audio cord
(not supplied)
To Audio
IN
To Component
OUT
Video cord
(not supplied)
This television is only capable of displaying
480i interlaced signal when connected to a
digital device with component video outputs.
If you input a 480p, 720p, or 1080i signal to
the component video inputs, COMPONENT
is displayed on a black screen. If
COMPONENT appears, set the digital
device's component output to 480i.
7