Adjusting The Bevel Stops; Adjusting The Blade Height; Using The Miter Gauge - ShopMaster DELTA S36-300 Guide D'utilisation

ADJUSTING THE BEVEL STOPS

Adjustment to the bevel stops may be required if the blade
is not vertically square to the table when bevel adjustment
is set at 0˚ or does not go to
Corrective adjustments can be made by adjusting the
bevel stop cams at each end of the bevel track as follows;
If the blade is not vertically square to the table, you must
adjust the 0˚ bevel stop cam (Fig. 32).
1. Unlock the bevel lock lever and position the height
adjustment wheel/bevel lock assembly to the right in
order to gain access to the
2. Loosen the cap screw that locks the
cam in place (center of the cam). As shown in Fig. 32
3. Move the height adjustment wheel/bevel lock
assembly to the 0˚ bevel stop cam making sure that
height adjustment wheel/bevel lock assembly is in
contact with the 0˚ bevel stop cam. Check blade
squareness to table with combination square, rotate
bevel stop cam as needed until blade is properly
square to the table.
4. Tighten the cap screw that locks the bevel stop cam
in place. Recheck to verify that blade is square to
table. Readjust as needed.
If blade does not check at
the 45˚ bevel stop cam, follow steps 1-4 by adjusting the
45˚ bevel stop cam using the
square (Fig 33).

ADJUSTING THE BLADE HEIGHT

For all through cuts, the top of the blade points should be
above the workpiece and the bottom of the blade gullets
are below the top surface of workpiece.
For non-through cuts, the top of the blade points should
be set to the depth of the cut.
To adjust the height of the blade, refer to Fig 34 and do the
following:
Make sure the bevel lock lever is in the locked (down)
position.
Adjust the blade height by turning the height adjustment
wheel. Clockwise will raise the blade and counterclockwise
lowers it.

USING THE MITER GAUGE

There are two miter gauge grooves, on either side of
blade. When making a 90˚
For beveled cross cut use the groove on right so that the
blade is tilted away from the miter gauge (G) and hands
(Fig. 35).
To adjust miter angle loosen the miter gauge lock knob.
Rotate the gauge until desired angle on scale is reached.
Tighten knob.
MAKING ADJUSTMENTS
45˚ when bevel is tilted to 45˚.
0˚ bevel stop cam.
0˚ bevel stop
45˚ to the table when tilted to
45˚ side of the combination
cross cut, use either groove.
0˚ STOP
LOCK
45˚ STOP
ADJUSTMENT
WHEEL
BEVEL
LOCK
GROOVES
G
24
cam screw
UNLOCK
FIGURE 32
cam screw
UNLOCK
LOCK
FIGURE 33
FIGURE 34
FIGURE 35