Connecting Other Equipment - Sony DVCAM DSR-20 Mode D'emploi

Connecting Other Equipment

For usage, connections, etc., refer to the instruction manual of the equipment to be connected.
Connecting an editing controller
You cannot execute video/audio insert editing. Only assemble editing is available with this VCR.
Notes
• You cannot edit tapes with the RS-232 protocol using this VCR as a recorder.
• When you edit tapes connecting FXE-120 or FXE-100 and using this VCR as a player, set the
RS-232C baud rate of the both units to 19200bps.
• When you edit tapes connecting FXE-100 and using this VCR as a recorder, you need to upgrade
FXE-100 by using FXE-KIT1 (not supplied).
• When you edit tapes connecting FXE-120 or FXE-100 and using this VCR as a recorder, you
cannot directly connect the units. Use the LANC interface box IF-FXE2.
Connecting a titler and a digital SEG
When connecting a titler and a digital SEG equipped with the S VIDEO jack, use the S VIDEO
connection.
Making a tape duplication system by connecting a number of DSR-20/20P units
• Make sure to use an audio/video distributor. If you make a loop connection, picture and sound
may deteriorate.
• When using a CONTROL S jack, you can make a loop-through connection. Check the command
mode of the wired remote commander and set the same mode on this VCR by the REMOTE
CONTROL menu (see page 35).
• You cannot use the following remote commanders with this VCR:
RM-250, RM-S18 and RM-S52A.
An example of the tape duplication system
DSR-20/20P
INPUT
SELECT
Audio output
DSR-200/200P
Audio output Video output
RS-232C
DUP
COUNTER AUDIO
TIMER
SELECT MONITOR
REMOTE
TC CH-1/2 REPEAT
COUNTER MIX OFF MENU
TAPE CH-3/4 REC
REMAIN LOCAL
SET
Video output
Video input
Audio input
Video input
Audio input
RS-422
LANC
IF-FXE2
(FXE-120)
FXE-100/120
Chapter 2 Recording and Playback
(FXE-100)
RS-422
(Recorder)
PGM
video
output
PGM audio output
33 EN