Zephyr Pisa ZPI-E24BG Guide D'utilisation, D'entretien Et D'installation page 18

Installation Instructions
Mounting the Hood
18
10. Place 6" round ducting over blower
collar and secure with aluminum
duct tape. If using hood in ductless
recirculating mode, refer to the Ductless
Recirculation section. Install electrical
wiring. Make sure no packing material
is inside hood. Power up hood check
for leaks around duct tape and verify all
functions.
11. Measure distance between back of
range hood and wall (if any) and cut
filler panel to the appropriate depth
using a utility knife or heavy-duty
scissors.
12. Install filler panel to bottom of hood by
(4) 3.5x10 screws for 24" model or (5)
3.5x10 screws for 30" and 36" model.
Pisa Use, Care, and Installation Guide
C O R E
P I S A
U N D E R - C A B I N E T