Mitsubishi Electric City Multi Série Manuel D'installation page 15

5. Installing the grille
A
Fig. 5-12
C
Fig. 5-13
i-See sensor
or signal
receiver
Vane
Fig. 5-14
D
Fig. 5-15
B
F
E
C
5.3.4. Wiring the i-See sensor corner panel and signal receiver
corners of the panel and install them.
and signal receiver in the connector box.
as shown in the diagram so that there is no slack in the wires, and then cut off the
excess end of the fastener. (Fig. 5-13)
panel.
Caution:
and secure the wires together with the fastener. (Fig. 5-15)
Make sure that the band securing the i-See sensor and signal receiver junc-
incorrectly, the vanes will not move or communication with the remote con-
troller will not be possible.
A i-See sensor
B Signal receiver
C Fastener
D Wire clip
E
F
-