Operating The Appliance; Switching On The Appliance; Switching Off And Disconnecting The Appliance - Siemens GI N Série Notice D'utilisation

en Operating the appliance
Ice cube tray
You can make ice cubes:
Fill the ice cube tray 3/4 full with
1.
water and place in the freezer
compartment.
If the ice cube tray is stuck to
Note:
the freezer compartment, loosen with
a blunt implement only (e.g. spoon
handle).
To loosen the ice cubes, twist the ice
2.
cube tray slightly or hold briefly
under flowing water.
Ice pack
In the event of a power failure or a fault:
The ice pack delays the warming of
■
the stored frozen food.
The longest storage time is
Note:
obtained by placing the ice pack on the
food in the top compartment.
You can take out the ice pack for
temporarily keeping food cool, e.g. in a
cool bag.
1
Operating the
appliance

Switching on the appliance

p l i a n c e O p e r a t i n g t h e a p
Press the # button.
1.
The appliance begins to cool.
Warning signal, flashing temperature
display on the freezer compartment
and lit button alarm indicate that the
freezer compartment is still too
warm.
Press the alarm button.
2.
The warning signal switches off.
Setting the required temperature.
3.
~ "Setting the temperature"
on page 29
28
Operating tips
After the appliance has been
■
switched on, it may take several
hours until the set temperature has
been reached. Do not put in any
food until the selected temperature
has been reached.
The fully automatic NoFrost system
■
ensures that the freezer
compartment remains free of ice.
Defrosting is not required.
The sides of the housing are partly
■
heated slightly. This prevents
condensation in the area of the door
seal.
If the freezer compartment door
■
cannot be immediately re-opened
after it has been closed, wait until the
resulting low pressure has
equalised.
Switching off and
disconnecting the appliance
Switching off the appliance
Press the # button.
■
The appliance no longer cools.
Disconnecting the appliance
If you do not use the appliance for a
prolonged period:
Press the # button.
1.
The appliance no longer cools.
Pull out the mains plug or switch off
2.
the fuse.
Clean the appliance.
3.
Leave the appliance open.
4.