Installation And Operation - Laserworld Garden Star Série Mode D'emploi

Manual: Laserworld Garden Star Series
GS-70RG move, GS-100RGB move (white edition)
Manufacturer / Representative notice on the back site
Notices on the Remote
The remote control supplied with This product contains a button cell battery. If the button cell battery is
swallowed, it can cause severe internal b urns in just 2 hours and can lead to death.
If the battery compartment does not close securely, stop using the product and keep it away from
If you think batteries might have been swallowed or placed in-side any part of the body, seek immedate

5. Installation and operation

1. Choose a suitable indoor or outdoor location for your laser light effect.
2. Installation:
• Bolt the angle bracket together using the screw included in delivery.
• Screw the angle bracket to the thread on the bottom of the the laser unit. Make sure to
only hand-tighten the angle bracket to not tear out the thread.
• Screw the stake to the other end of the angle bracket, make sure to only hand-tighten
the stake.
3. Connect the psu adapter to the power cable of the device. Connect the power adapter to mains.
4. Your laser device starts to project immediately.
5. Disconnect the device from mains to switch off the laser light effect.
WARNING
Do not ingest the battery, Chemical Burn Hazard
Keep new and used batteries away from children.
children.
medical attention.
English