Legal Notice; Product And Package Contents; Preliminary Warning Notices; Initial Operations, Safety Instructions - Laserworld Garden Star Série Mode D'emploi

Manual: Laserworld Garden Star Series
GS-70RG move, GS-100RGB move (white edition)
English Version

Legal notice:

Thank you for purchasing this Laserworld product.
Due to continual product developments and technical improvements, Laserworld (Switzerland) AG re-
serves the right to make modifications to its products.
This manual and its content have been made with due care but Laserworld (Switzerland) AG cannot
however, take any responsibility for any errors, omissions or any resulting damages forthwith.
The brands and product names mentioned in this manual are trade marks or registered trade marks of
their respective owners.
Operating instructions and usage policy: The laser systems of the Laserworld Garden Star Series
are intended for private use only. This device is no toy and must not be operated by minors or
children!

1. Product and package contents

Please check if all listed parts are included and undamaged. Included in delivery:
1 x laser light effect
1 x power supply unit

2. Preliminary warning notices

1.
Please use this device only according to these operating instructions.
2.
Do not use the device if there are any visible damages on housing, power adapter or power
cords.
3.
Never look directly into the light source of a laser projector.
4. This device is manufactured according to protection class IP65. It is dust-proof and protected
against temporary submergence. Do not operate the device under water.

3. Initial operations, safety instructions

1.
Make sure to use correct voltage; see infor-
mation in this manual.
2.
Make sure that the device is not connected
to mains during installation.
3.
Installation has to be done according to sa-
fety regulations of the respective country.
4.
If the device has been exposed to great
temperature changes, do not switch it on
immediately. Condensation may damage
device.
5.
Never use dimmer, RC or other electroni-
cally switched sockets.
1 x remote control unit
1 x stake
6.
Ensure sufficient ventilation and do not
place the device on any warm or heat radi-
ating surface. Ensure that the device does
not get overheated.
7.
Operating temperatures: -20° C up to +40°C
8.
The operation of the device below -15°C
may result in reduced output power and
below -20°C laser output may stop. This is
not a deficiency, but derives from general
physical principles. When the temperatures
rise above the given temperatures the laser
runs at normal level again.
9.
This unit is intended for indoor and outdoor
use.
English
1 x manual