SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 76

EN
> dePRogRAMMIng The ReMoTe ConTRols and radio accessories
this procedure erases all radio programming
1- Press P1 and hold down
2- dl1 lights up
3- dl1 goes out
4- 100% of the radio accessories are closed
So :
Press P1
keep depressed
dl1 On
dl1 off
radio parts are erased
Release
> desCRIPTIon And ChARACTeRIsTICs oF The CTR 52 PRInTed CIRCuIT BoARd
dl1 → Red programming LED. The LED lights up during the programming phase while the gate is moving.
Rv1 → Adjusts gate thrust force (stop on obstacle).
Programming buttons P1, P2 and P3:
• P1 → Button to recognize or erase the radio parts of your installation.
• P2 → Button to programme gate opening and closing times.
• P3 → Button to adjust pause time (between the end of the gate opening and it automatically closing).
> oPeRATIng Mode oF youR AuToMATIon sysTeM
3 modes are available
1/ seMI-AuToMATIC Mode (set by default)
Press on the remote control Close gate
Open gate Press on the remote control
Reaches the limit stops the gate stops
With this solution you must use your remote control to open and close the gate
▌PRACTICAL EXAMPLE
Press on the remote controle
......... 2 press the gate stops 3 press
è è
on the remote controle
Open or close the gate closes
en ::: 30