SCS Sentinel Kit automatisme vérins Manuel D'installation Et D'utilisation page 66

EN
hole used
FAsTenIng 1
example of the
part not used
Identify the unused part of the fastening.
Cut off the unused part with a saw.
> dePloyIng The ARM By hAnd
When installing your automation system, you can deploy the arm by turning the mobile tube anti-
clockwise. to retract it, turn the tube clockwise.
Deploying the arm Retracting the arm
> PosITIonIng The ARMs on The gATe
Close the gate. Deploy the arm to dimension C=960
mm (see above for how to deploy the arm).
Place the operator on the fastening with the aid of
the screw. Place the first washer under the screw
head and the other under the nut.
tighten the supplied nut without locking it.
If it is too tight, this can damage the motor's rear
retaining bracket.
FIxATIon 2
> TRAvel sToPs
This gate motorization kit is a self-locking motorization system. Your gate with two leaves must be
equipped with central and lateral limit stops (not supplied). the central and side limit stops must stop
the gate without locking it. In other words, any mechanical lock (or strike plate) and any swivelling
shoe or stop pin must be removed.
en ::: 20