Care And Cleaning; Emergency Operation [For Wireless Remote Controller] - Mitsubishi Electric Mr.SLIM SLZ-KA25VA Manuel D'utilisation

2. Operation
[4]–4. Display change setting
(1) Temperature display °C/°F setting
• To switch the setting, press the [
1 °C : The temperature unit °C is used.
2 °F : The temperature unit °F is used.
(2) Suction air temperature display setting
• To switch the setting, press the [
1 ON : The suction air temperature is displayed.
2 OFF : The suction air temperature is not displayed.
(3) Automatic cooling/heating display setting
• To switch the setting, press the [
1 ON : One of "Automatic cooling" and "Automatic heating" is displayed under the automatic mode is running.
2 OFF
: Only "Automatic" is displayed under the automatic mode.
SLP-2AL (For SLZ-KA25/KA35/KA50VAL)

3. Care and cleaning

A
14
ON/OFF] button D.
ON/OFF] button D.
ON/OFF] button D.
A B C D E
B
D
2.14. Emergency operation
[For wireless remote controller]
When the remote controller cannot be used
When the batteries of the remote controller run out or the remote controller
malfunctions, the emergency operation can be done using the emergency
buttons on the grille.
ADEFROST/STAND BY lamp
BOperation lamp
CEmergency operation switch (heating)
DEmergency operation switch (cooling)
EReceiver
Starting operation
• To operate the cooling mode, press the
• To operate the heating mode, press the
Note:
• Details of emergency mode are as shown below.
Details of EMERGENCY MODE are as shown below.
Operation mode
Set temperature
Fan speed
Airflow direction
Stopping operation
• To stop operation, press the
Caution:
• Always turn off the power, first on the remote controller and then
the main switch, before cleaning or servicing the unit.
• When installing or removing the filter or the intake grille, do not
stand on an unsteady surface. You may fall and injure yourself. Be
also careful not to let dust fall into your eyes.
Dirty or clogged filters block the airflow and reduce efficiency. Very dirty
filters can damage the air-conditioner itself.
Intake grille removal
C
1Pull the catch on the intake grille in the direction indicated by the arrow
and it should open.
2Unhook the hinges to remove the intake grille from the grille.
Filter removal
1Open the intake grille.
2Release the catch on the center edge of the intake grille and pull the
filter forward to remove the filter.
A Catch B Grille
button D.
button C.
COOL HEAT
24°C 24°C
High High
Horizontal 30° Downward 70°
button D or the button C.
C Intake grille D Filter