Aspire Puxos Manuel D'utilisation page 52

Using the Device
Selecting the Operation Modes
By pressing the "+" and Fire button at the same time for half a second, it is possible to
choose between the "Wattage", "Voltage", "Bypass", "CPS" (C1/C2/C3), "TC"
(Ni, Ti, SS316L) and "TCR" (M1/M2/M3) modes. You can navigate through the menu with
the "+" and "-" buttons, confirming your selection with the Fire button.
Settings in TCR Mode
Once you have selected TCR Mode, you can access the "PWR" and "TCR" settings by
pressing the "+" and "-" buttons at the same time. Press the Fire button to choose between
these settings. You can now alter the calibration with the "+" and "-" buttons. You can set the
wattage between 1W and 80W or 100W in "PWR", while you can access the fine
calibration range between 0.10‰ and 0.99‰ in "TCR". (Note: ‰=×10 ) The settings
-3
cannot be adjusted for TC (Ni/Ti/SS316L).
In Watts mode, you can also set the intensity in addition to wattage. „H" stands for „hard",
„N" stands for „normal" and „S" stands for „soft".
50