Waring Commercial MX Série Mode D'emploi page 6

3. Grasp sides at pivot boss and separate to remove door.
NOTE: A rubber o-ring can be found on each of the pivots. Leave these
o-rings in place to ensure proper performance
4. To clean door, wipe with a damp cloth. Not for waterjet cleaning
NOTE: Remove rubber jar pad to clean underneath.
To replace sound enclosure door, follow these steps:
1. Replace rubber jar pad.
2. Replace door at pivot boss and attach to secure door.
3. Insert blender container and close sound enclosure.
mX elecTronic ToUcH PaD SWiTcHeS WiTH Timer
1. Before starting, make sure that the blender is
unplugged.
2. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
3. Put ingredients into container and cover it. Do not
fill above MAX line.
4. This blender is equipped with an electronic membrane keypad. The
keypad has a main power STANDBY
and PULSE
and DOWN
5. Press the STANDBY
illuminate. The electronic timer will indicate 10 seconds (default). Press
the UP
timer will indicate run time in 5-second intervals up to a maximum of 30
seconds. After the desired time is set, press HI
blender. The timer will count down to 0 in 1-second intervals and blend-
er will shut off. Pressing the PULSE
the STANDBY
regardless of time left on timer.
noTe: If you want to increase or decrease time while timer is counting
down, press UP
in 5-second intervals.
6. If the blender is not used for five seconds, the timer function will turn
"Off" and return to manual mode. To reactivate timer, press UP
DOWN
will be the last time set. note: If unit has been turned off or unplugged,
the timer will default back to 10 seconds.
7. For continuous operation, press either LO or HI
finished blending, press STOP
the PULSE
released.
noTe: Your MX Electronic Blender utilizes a Slow Start
pressing HI
then switch to HI
ingredients in container.
buttons and a 30 second count down timer with UP
arrows to set time.
button to turn on the blender. Green LED will
or DOWN arrow to set the desired time. The electronic
button will override the timer and the blender will stop
or DOWN
arrows. When using the electronic timer again, the initial time
button. Motor will run on HI
, the unit will start in the LO
speed. This allows for a more even blending of
button, plus HI
button, the STOP
arrows. Time will increase or decrease
. For momentary operation, press
speed until the button is
speed for 2 seconds and
6
, LO , STOP
or LO to start the
button or
button. When
feature. When
™
or