Waring Commercial MX Série Mode D'emploi page 5

6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
8. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
9. To turn unit off, press STANDBY
1. Before starting, make sure that the blender is unplugged.
2. With Sound Enclosure door open, place container
on blender base. Be sure container is fully seated
and that drive coupling is properly engaged. Plug
blender cord into outlet.
3. Put ingredients into container and cover it. Do not
fill above MAX line. Close Sound Enclosure door.
4. This blender is equipped with an electronic
membrane keypad. The keypad has a main power
STANDBY
buttons.
5. Press the STANDBY
illuminate. For continuous operation, press either LO
When finished blending, press STOP
press the PULSE
button is released.
noTe: Your MX Electronic Blender utilizes a Slow Start
pressing HI , the unit will start in the "Low" speed for 2 seconds and
then switch to HI
ingredients in container.
6. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
7. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
8. To turn the unit off, press STANDBY
go off.
mX inTernaTional – SoUnD encloSUre inSTrUcTionS
SoUnD encloSUre
Your MX Series blender is equipped with a heavy-duty polycarbonate
sound enclosure to reduce noise level while blending. The sound enclosure
door is removable for cleaning. To clean, wipe with damp cloth. not for
waterjet cleaning.
To remove sound enclosure door, follow these steps:
1. Open sound enclosure and remove blender container.
2. Close door.
mX elecTronic ToUcH PaD SWiTcHeS
WiTH SoUnD encloSUre
button, and HI
button to turn on the blender. Green LED will
button; motor will run on HI
speed. This allows for a more even blending of
button. Green LED light will go off.
and LO , STOP
. For momentary operation,
button. Green LED light will
5
and PULSE
or HI button.
speed until the
feature. When
™