Integrated Cleaning Programme - Melitta Caffeo Bistro Guide D'utilisation

11.4 Integrated cleaning programme

The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning button
For optimal cleaning results, we recommend that you clean the brewing unit
beforehand (see page 67).
Prerequisite: The appliance is in stand-by mode (see „Switching on and off"
on page 54).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning
– Only use Melitta
cleaning tabs are designed specifically for Melitta
other cleaning agents can damage the appliance.
Run the integrated cleaning programme as follows:
1 Remove the Melitta
(see page 55).
2 Press the button for one-cup dispensing
simultaneously for about 3 seconds.
→ The symbol for cleaning
The drip tray symbol
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, one bean symbol
→ First, two automatic rinsing processes are carried out.
The ground coffee chute symbol
68
Heft_Caffeo_Bistro_EU_2.2.indd 68
flashes during the entire process.
cleaning tabs for fully automatic coffee makers. These
®
Claris water filter – if used – from the water tank
® ®
flashes.
illuminates.
is shown on the display.
lights up on the display.
CAFFEO . The use of
® ®
and the ON/OFF button
illuminates.
09.04.2014 14:33:54