Bosch Rotak 320 ER Notice Originale page 11

OBJ_BUCH-2960-001.book Page 11 Tuesday, August 2, 2016 3:32 PM
 Regularly inspect the supply cable
and any extension cables. Do not con-
nect damaged cables to the supply or
touch a damaged cable before it is
disconnected from the supply. A
damaged cable can lead to contact
with live parts. Beware electric shock
hazard.
Remove the plug from the socket:
– Whenever you leave the machine.
– before clearing a blockage,
– before checking, cleaning or working
on the machine,
– after striking a foreign object. Inspect
the machine for damage and make re-
pairs as necessary,
– if the machine starts to vibrate abnor-
mally (check immediately).
Connecting to the mains
 The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
 We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
 Only use or replace power supply ca-
bles for this unit which correspond to
the types indicated by the manufac-
turer. See the operating instructions
for the order no. and types.
 Never touch the mains plug with wet
hands.
 Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
Bosch Power Tools
 The extension lead must have a cross
section in accordance with the oper-
ating instructions and be protected
against splashed water. The connec-
tion must not be in water.
Always wear gardening gloves when han-
dling or working near the sharp blades.
Electrical Safety
 Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, damaged
or entangled.
 The blades continue to rotate for a
few seconds after the machine is
switched off.

Caution – do not touch the rotating
blade.
Your machine is double insulated for
safety and requires no earth connec-
tion. The operating voltage is 230 V AC,
50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use ap-
proved extension cables. Contact your
Bosch Service Centre for details.
Extension cords/leads should only be
used if they comply with H05VV-F,
H05RN-F types or IEC type design
(60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable
when operating your product, only the
following cable dimensions should be
used:
2
– 1.0 mm : max. length 40 m
2
– 1.5 mm : max. length 60 m
2
– 2.5 mm : max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
English | 11
F 016 L81 624 | (2.8.16)