Bosch GKS 65 Professional Notice Originale page 17

Technical data
Handheld circular saw
Article number
Rated power input
No-load speed
Max. speed under load
Max. cutting depth
– at a 0° mitre/bevel angle
– at a 45° mitre/bevel angle
Spindle lock
Speed preselection
Constant electronic control
Temperature-dependent overload pro-
tection
Starting current limitation
Base plate dimensions
Max. saw blade diameter
Min. saw blade diameter
Max. base blade thickness
Max. tooth thickness/offset
Min. tooth thickness/offset
Locating bore
Weight according to
EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Only for power tools without starting current limitation: Switching these on causes the voltage to drop briefly. Interference
with other tools may occur in the event of unfavourable conditions in the electricity supply. Malfunctions are not expected if
the impedances in the electricity supply are below 0.36 ohms.
Fitting
Only use saw blades the maximum permitted speed of
u
which is higher than the no-load speed of the power
tool.
Inserting/changing the circular saw blade
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Wear protective gloves when fitting the saw blade.
u
Danger of injury when touching the saw blade.
Only use saw blades that match the specifications
u
given in this operating manual and that are tested and
marked in accordance with EN 847-1
Do not use abrasive wheels as the application tool un-
u
der any circumstances.
Bosch Power Tools
GKS 65
3 601 F67 0..
W 1600
rpm 5900
rpm 4200
mm 65
mm 48
mm 170 x 305
mm 190
mm 184
mm 1.7
mm 2.6
mm 1.8
mm 30
kg 4.8
/ II
Selecting the saw blade
You will find an overview of recommended saw blades at the
end of these operating instructions.
Removing the saw blade (see figure A)
To change tools, we recommend that you place the power
tool down on the front side of the motor housing.
– Press and hold the spindle lock button (5).
Do not press the spindle lock button (5) while the saw
u
spindle is moving. The power tool may become damaged
if this happens.
– Use the hex key (18) to undo the clamping bolt (19) in ro-
tational direction ➊.
– Swing the retracting blade guard (12) back and hold on
to it firmly.
– Remove the clamping flange (20) and the saw blade (21)
from the saw spindle (23).
GKS 65 G
3 601 F68 9..
1600
5900
4200
65
48
● ●
– –
– –
– –
– –
203 x 327
190
184
1.7
2.6
1.8
30
5.1
/ II
1 609 92A 4LP | (19.11.2018)
English | 17
GKS 65 GCE
3 601 F68 9..
1800
2300–5000
1400–4000
65
48
●
●
●
●
●
203 x 327
190
184
1.7
2.6
1.8
30
5.2
/ II