Assembly; Operation - Ryobi RY40406 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Blower
Blower Tube
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.

ASSEMBLY

Do not attempt to modify this product or create acces-
sories not recommended for use with this blower. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
tool when assembling parts.
INSTALLING THE BLOWER TUBE
See Figure 2.
 Align raised tabs on blower housing outlet to the slots on
tube; slide together and tighten securely by twisting until
the tubes snap into the locked position. Check tightness
after initial use and retighten if needed.
NOTICE:
When correctly assembled, the tube is difficult to
separate. If it can easily be twisted apart, the tube is not
locked. Continue twisting together until the tube snaps
into the locked position. If the tube is not in the locked
position, it can separate during blower operation.
 To remove the tube, rotate the tube and remove from the
blower housing outlet.

OPERATION

Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
6 — English
WARNING:
WARNING:
WARNING: