Ryobi RY40406 Manuel D'utilisation page 9

WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
APPLICATIONS
You may use this product for the purposes listed below:
 Clearing leaves and other debris from your lawn
 Keeping decks and driveways free from grass clippings,
leaves, pine needles, and other debris
INSTALLING/REMOVING BATTERY PACK
See Figure 3.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Place the battery pack in the blower. Align the raised rib
on the battery pack with groove in the blower's battery
port.
WARNING:
Make sure the latch on the bottom of the battery pack
snaps in place and the battery pack is fully seated and
secure in the blower battery port before beginning opera-
tion. Failure to securely seat the battery pack could cause
the battery pack to fall out, resulting in serious personal
injury.
OPERATION
NOTICE:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the tool and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
To remove:
 Locate the latch on the bottom of the battery pack and
depress to release the battery pack from the blower.
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF position when not in
use or carrying at your side. Remove battery pack when
transporting or carrying blower to avoid accidental start-
ing, which could result in serious injury.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
STARTING/STOPPING THE BLOWER
See Figure 4.
 To start the blower, depress the switch trigger.
 To stop the blower, release the switch trigger.
USING TURBO BOOST
See Figure 4.
 While the switch trigger is depressed, press the turbo
boost to increase the air flow to the maximum velocity.
NOTE: The blower will return to normal speed when the
button is released.
OPERATING THE BLOWER
See Figure 5.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 To reduce sound levels, limit the number of pieces of
equipment used at any one time.
 Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
 Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas such
as gutters, screens, patios, grills, porches, and gardens.
7 — English
WARNING: