AEG HK764403IB Notice D'utilisation page 10

10 www.aeg.com
Refer to "Technical information" chapter.
4.5 Bridge function
The function operates when
the pot covers the centres of
the two zones.
This function connects two cooking
zones and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the function for left / right
cooking zones: touch
change the heat setting touch one of the
left / right control sensors.
To deactivate the function: touch
. The cooking zones operate
independently.
4.6 Automatic Heat Up
Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
Immediately touch a desired heat
setting. After 3 seconds
To deactivate the function: change the
heat setting.
4.7 Power function
This function makes more power
available to the induction cooking zones.
min.
max.
/ . To set or
( comes on).
comes on.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to "Technical
information" chapter.
To activate the function for a cooking
zone: touch
To deactivate the function: change the
heat setting.
4.8 Timer
You can set one timer function for each
cooking zone separately. To set a timer
function for the zones on the left side use
the timer on the left, for the zones on the
right, the timer on the right.
Count Down Timer
Use this function to specify how long a
cooking zone should operate during a
single cooking session.
First set the heat setting for the cooking
zone and then set the function.
/
To activate the function or change the
time: touch
until the indicator
lights up on the display. Then touch
or to set the time (00 - 99 minutes).
The function starts automatically after 4
seconds. comes on the display.
To activate the timer function for the
second zone in a pair touch
quickly.
When the time comes to an end, a signal
sounds and 00 flashes. Touch
the signal.
To see the remaining time: touch
To deactivate the function: choose the
desired zone touching
. The remaining time counts back to
00. The symbol
. comes on.
quickly again and again
of a given zone
3 times
to stop
and then touch
goes out.
.