Fimer TT 258 EVO Mode D'emploi page 46

3. Once the password has been confirmed
the display will show the message in Fig.
C, a lock symbol in the area 1 of the
display and the functions Unlock
Reset pw (reset password) which
correspond to buttons 2 and 3 (fig. 1)
respectively, in area 2 of the display;
4. To exit the lock option of the work
stage, briefly press switch 9 in fig. 1;
5. Should the need to modify the work
stage arise, activate the 'Unlock'
by pressing the function button. The
unlock function will require the user to
enter the password that was set and
activated as described above.
6. The reset password option can be
activated by pressing the
button.
WARNING:
The Reset Password option should
only be used when there is no way of
tracing the work stage and when the
Lock/Unlock password has been lost.
To use this function
constructor technical
department directly.
18
Appendix:
titles/button symbols/function buttons
and pop-up notifications
In the following figure and table, you will find
and
the descriptions of the principal title/button
symbols/function
notifications, with regard to error messages
that may appear on the display:
Symbol
option
(Reset pw)
contact the
support
buttons and
Position
on Description
display
If information needs to be
entered by the user, this
F4 key
button must be pressed to
confirm the data
Press this button in the
event user data is requi-
F3 key
red and you need to can-
cel the operation;
In the event there is a
request for the user to
F1 key
enter data, use this but-
ton to cancel the last digit
entered;
When the keyboard lock
function is activated, using
F1 key
switch 10 (fig.1), this but-
ton must be pressed to
deactivate the lock.
When the keyboard lock
function
F1 key
using switch 10 (fig.1),
this button must be pres-
sed to activate the lock.
pop-up
F1 Key
F2 Key
F3 Key
F4 Key
is activated,