Fimer TT 258 EVO Mode D'emploi page 29

USER AND MAINTENANCE MANUAL
USER AND MAINTENANCE MANUAL
Fimer S.p.A. would like to thank you for choosing this machine; if used according to the
instructions reported in this user and maintenance manual, it will accompany you in your
work for many years without any problems.
This manual is an integral part of the machine and must accompany it whenever moved
or resold.
The user is responsible for making sure the machine is complete and in good working
order. The manufacturer has the right to make changes at any time, without notice.
Each Fimer product has been designed, built and made in Italy.
This is guarantee of maximum quality and reliability.
No part of this manual may be translated into another language, adapted or reproduced with any means (including
scanned documents, photocopies, film and microfilm) without the prior written consent of the manufacturer.
INDEX
INDEX
• CAUTION.......................................................................................................... pag. 2, 3, 4
1. GENERAL SPECIFICATIONS AND NOTES FOR
CONSULTING THIS MANUAL....................................................................... pag. 5
2. DESCRIPTION OF THE EQUIPMENT ........................................................... pag. 6
3. MMA WELDING............................................................................................ pag. 7
3. 1 MMA WELDING Manual .............................................................................. pag. 7
4. WELDING TABLE.......................................................................................... pag. 8
5. CONNECTION FOR MMA WELDING............................................................. pag. 8
6. IGNITING THE MMA ARC............................................................................. pag. 8
7. TIG WELDING.............................................................................................. pag. 9
7. 1 PULSED TIG WELDING................................................................................ pag. 10
7. 2 TIG WELDING (Lift-Arc).............................................................................. pag. 10
7. 3 TIG AUTOMATIC SPOT WELDING IN 2T AND 4T MODES............................. pag. 12
7. 4 TIG WELDING (Hf)....................................................................................... pag. 14
8. CONNECTOR FOR TIG WELDING .................................................................. pag. 15
9. POWER CONNECTOR................................................................................. pag. 16
10. REMOTE CONNECTION............................................................................... pag. 16
10.1 REMOTE CONTROL OF THE WELDING CURRENT...................................... pag. 16
11. CONNECTING THE OUT-PUTS..................................................................... pag. 16
12. CONNECTING THE GAS CYLINDER AND THE GAS REGULATOR........................ pag. 16
13. ORDINARY MACHINE MAINTENANCE ....................................................... pag. 16
14. MEMORISING THE WORK POINT................................................................... pag. 17
15. LOCKING A WORK POINT........................................................................... pag. 17
16. ERROR CODE.............................................................................................. pag. 20
17. TROUBLESHOOTING.................................................................................. pag. 21
18. BLOCK DIAGRAM....................................................................................... pag. 22
19. TT 258EVO - TT 305EVO SPARE PARTS.................................................... pag. 23
20. TT 425EVO SPARE PARTS.......................................................................... pag. 24
1