Ryobi RY401011 Manuel D'utilisation page 14

NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
APPLICATIONS
You may use this product for the purpose listed below:
 Mowing your lawn
WARNING:
Always remove battery packs and start key when moving
or transporting the mower to avoid accidental starting
that could result in serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figure 10.
 Raise the battery cover.
 Align raised ribs on battery pack with grooves in the bat-
tery port and install the battery pack into the mower.
WARNING:
Make sure the latch on the bottom of the battery pack
snaps in place and the battery pack is fully seated and
secure in the mower's battery port before beginning op-
eration. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious
personal injury.
 Lower the battery cover and make sure it is securely
closed.
To remove battery pack:
 Raise the battery cover.
 Press and hold the battery latch button at the bottom of
the battery pack.
 Remove battery pack from the mower.
 Lower the battery cover and make sure it is securely
closed.
For complete charging instructions, refer to the Operator's
Manuals for your RYOBI battery pack and charger models.
WARNING:
To avoid accidental starting that could result in serious
personal injury, always remove the start key when moving
or transporting the mower.
OPERATION
NOTE: The battery storage compartment offers a convenient
place for storing your battery, or to store an extra battery
pack. The unit cannot be powered by the battery while it
is installed in the battery storage compartment; it must be
moved to the battery port in order to power the unit from
the battery port.
STARTING/STOPPING THE MOWER
See Figures 11 - 12.
NOTE: Mower will not start without the grass catcher or
mulch plug attached, the start key installed, and the battery
in the unit.
 Raise the battery cover.
 Install battery pack into the battery port.
 Insert the start key into the slot beside the battery storage
compartment.
 Lower the battery cover.
 Raise the handle assembly as described earlier.
NOTE: The mower will not start if the handle assembly
is not in the operating position.
 Press and hold the start button. Pull the bail toward the
handle and release the button to start the mower and
blades.
NOTE: The motor and blades will also start if the bail is
pulled first and the start button is pressed after.
 To stop the mower, release the bail.
MOWING TIPS
WARNING:
Do not mow on wet grass, which can cause you to slip
and fall and result in possible serious personal injury.
NOTE: Fully charge battery before each use for optimal
runtime.
 Make sure the lawn is clear of stones, tree nuts, sticks,
wires, and other objects that could damage the lawn mower
blades or motor. Do not mow over property stakes or other
metal posts. Such objects could damage the blade or be
accidentally thrown by the mower in any direction and
cause serious personal injury to the operator and others.
 For a healthy lawn, always cut off one-third or less of the
total length of the grass.
 When cutting heavy grass, reduce walking speed to allow
for more effective cutting and a proper discharge of the
clippings.
 Do not cut wet grass. It will stick to the underside of the
deck and prevent proper bagging or mulching of grass
clippings.
 New or thick grass may require a narrower cut or a higher
cutting height.
10 — English