WIKA S-20 Mode D'emploi page 13

3. Specifications
Electrical connections
Electrical connection
Angular connector DIN EN 175301-803 A
with mating connector
with mating connector (conduit)
with mating connector with
moulded cable
with mating connector with
moulded cable, shielded
Angular connector DIN EN 175301-803 C
with mating connector
with mating connector with
moulded cable
Bayonet connector (6-pin)
Circular connector M12 x 1 (4-pin)
without mating connector
with mating connector, straight
with moulded cable
with mating connector, straight,
with moulded cable, shielded
with mating connector, angled, with
moulded cable
2) Only applies when plugged in using a suitable mating connector that has the appropriate ingress protection
WIKA operating instructions pressure transmitter, model S-20
Ingress Wire cross-
protection section
2)
IP 65 max. 1.5 mm²
IP 65 max. 1.5 mm²
IP 65 3 x 0.75 mm²
IP 65 6 x 0.5 mm²
IP 65 max. 0.75 mm² 4.5 ... 6
IP 65 4 x 0.5 mm²
IP 67 -
IP 67 -
,
IP 67 3 x 0.34 mm²
IP 67 3 x 0.34 mm²
IP 67 3 x 0.34 mm²
Cable ∅ Cable Permissible temperature
material
6 ... 8 mm - -30 ... +100 °C
(-22 ... +212 °F)
- - -30 ... +100 °C
(-22 ... +212 °F)
6 mm PUR -30 ... +100 °C (cULus: -25 ... +85 °C)
(-22 ... +212 °F (cULus: -4 ... +185 °F))
6.8 mm PUR -25 ... +85 °C
(-4 ... +185 °F)
- -30 ... +100 °C (-22 ... +212 °F)
mm
6.2 mm PUR -25 ... +85 °C
(-4 ... +185 °F)
- - -40 ... +125 °C
(-40 ... +257 °F)
- - -30 ... +100 °C
(-22 ... +212 °F)
4.3 mm PUR -25 ... +80 °C
(-4 ... +176 °F)
4.3 mm PUR -25 ... +80 °C
(-4 ... +176 °F)
5.5 mm PUR -25 ... +80 °C
(-4 ... +176 °F)
GB
13