Trouble Shooting - KOBE Brillia Série Manuel D'installation Et Mode D'emploi

TROUBLE SHOOTING

Issue Possible Cause
After The power is not on.
Installation,
both motors
and lights are
The wire connection is not secure.
not working.
The control panel and processor
board wiring are disconnected.
The control panel and processor
board is defective.
Lights are The motor(s) is defective.
working, but
The capacitor(s) is defective.
motor(s) is not.
The control panel or processor board
is defective.
The range hood The blower system is not secure.
is vibrating.
The turbine impeller/squirrel cage is
not balanced.
Hood is not secured in place.
The motor is LED light fixture(s) is defective.
working, but the
lights are not
The light wiring(s) is loose.
working.
The control panel or processor board
is defective.
The range hood The range hood is installed outside
is not venting of the manufacture recommended
out correctly. clearance.
There is no make-up air inside the
house.
Obstacle blocking the pipe work.
The pipe size is smaller than the
suggested pipe size.
Cold air is The pipe connection is not properly
coming into the sealed.
home.
The damper is not properly installed
or is missing from the installation.
The damper is not installed.
Solution
Make sure the circuit breaker and the unit's
power is ON. Use a voltage meter to check the
power supply.
Check and tighten wire connection.
Check wire continuity from control panel to
processor board.
Replace the control panel or processor board.
Replace the motor.
Replace capacitor(s).
Replace the control panel or processing board.
Tighten the turbine impeller/squirrel cage and
air chamber.
Replace the turbine impeller/squirrel cage.
Check the installation of hood, tighten the
mounting bracket.
Replace LED light fixture(s)
Check wire continuity from processor board to
light transformer to LED light fixture(s).
Replace the control panel or processing board.
Adjust the clearance between the range hoods
and cook top to 26" to 30". For Island range
hood, the clearance between the range hoods
and cook top is 30" to 36".
Open the window to enhance the performance
of the range hood by creating a sufficient make-
up air.
Remove all obstacles from the duct work.
Change the ducting according to the
manufacture suggestion.
Check the pipe installation.
Check the damper installation.
Installing the damper will help eliminate air
backflow.
20