KOBE Brillia Série Manuel D'installation Et Mode D'emploi page 13

Wiring to Power Supply
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. RISK OF ELECTRICAL SHOCK.
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
4. If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
5. Store wires in the wiring box.
Duct Cover Installation
6. Mark the position of the Duct Cover-Mounting
Bracket {M}. Use reference E from Table 2 and
measurements on page 15-16.
secure Duct Cover-Mounting Bracket {M} with
two screws (provided). (Figure 6) NOTE: Inner
duct cover will cover the duct cover-mounting
bracket.
7. Position the entire duct cover up onto the hood.
8. Secure the inner duct cover with two (3/16" x
3/8") screws {J} to the duct cover-mounting
bracket. Shown in Figure 7.
9. Fasten outer duct cover to Duct Cover Support
{L} with four (4 x 6 mm) screws {J}.
Install Accessories
10. Place baffle filters & spacers underneath the
hood. (Figure 8)
Final Installation
11. Turn power ON in control panel. Check all lights
and fan operation.
Make sure to leave this manual for the
homeowner.
SERVICE PANEL TO
Attach and
Figure 6
Figure 7
Figure 8
11
Attach Together