EINHELL NEW GENERATION NWL 90 Mode D'emploi page 7

Anleitung NWL 90 SPK1 08.09.2006
1. Layout (Fig. 1)
1 Angle laser
2 On/Off switch
3 Spirit-level
4 Level setting wheel
5 Laser outlet hole
6 Positioning foot
7 Battery compartment cover
8 Level base
9 Setting screw for level base
10 Screw for level base
11 Extension sleeve
12 Laser aiming device
2. Safety information
Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation
nach EN 60825-1: 1994+A1: 2002+A2: 2001
Laser Klasse 2 JG-21
P: ≤ 5 mW
Ï: 650 nm
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
3. Use (Fig. 3a - 3c)
This device is used for alignment jobs, for making
room partitions, for laying floor tiles or parquet
flooring, and for vertical applications such as
installing walls made of plasterboard and the like.
12:10 Uhr Seite 7
4. Technical data
Accuracy
Operating temperature
Laser class
Laser wave length
Laser output
Laser power supply
Weight
5. Operation
Inserting and changing batteries (Fig. 4)
Important! Always make sure that the laser is
switched off before you insert the batteries!
Open the battery compartment cover (7) as shown in
Fig. 4 and insert the batteries supplied. Check that
the battery terminals are positioned correctly.
Use only alkaline-manganese batteries. Do not mix
batteries from different manufacturers. Use batteries
with the same capacity.
Switching on (Fig. 1): To switch the laser on, press
the On/Off switch (2) once.
Switching off (Fig. 1): To switch the laser off, press
the On/Off switch (2) twice.
Working without the level base (Fig. 1)
Place the positioning foot (6) on the starting point of
the angle. Align the angle laser with the help of the
level setting wheels (4) and the spirit-levels (3).
Switch on the angle laser. You can now mark the
exact angle lines.
Working with the level base (Fig. 1/2)
The level base is used to compensate major
unevenness on the standing surface. As shown in
Fig. 2, screw the setting screws (9) and the screw
(10) in the threads provided. Then place the angle
laser on the level base. Make rough adjustments with
the setting screws (9) and fine adjustments with the
level setting wheels (4). Three extension sleeves
(11) are provided for extreme unevenness. They are
simply plugged onto the setting screws (9) and the
screw (10).
GB
± 0.6 mm/m
-1-40°C
2
650 nm
≤ 5 mW
2 x 1.5 V (AA)
0.45 kg
7