Zanussi ZDT12002FA Notice D'utilisation page 20

German
degrees
(°dH)
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
Manual adjustment
1
Electronic adjustment
1. Press the on/off button to activate the appli-
ance.
2. Make sure that the appliance is in setting
mode. Refer to 'SETTING AND STARTING
A PROGRAMME'.
3. Press and hold the programme button until
the programme indicator (A) starts to flash
and the programme indicator (B) comes on.
4. Wait until the programme indicator (B) goes
off and the end indicator starts to flash (the
programme indicator (A) continues to flash).
20
Water hardness
French mmol/l
degrees
(°fH)
76 - 90 7.6 - 9.0
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
33 - 39 3.3 - 3.9
26 - 32 2.6 - 3.2
19 - 25 1.9 - 2.5
7 - 18 0.7 - 1.8
< 7
2
Turn the water hard-
ness dial to the posi-
tion 1 or 2.
Clarke
degrees
53 - 63
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 0.7 < 5
5. Press the programme button.
• The end indicator flashes intermittently.
The number of flashes shows the level of
the water softener, e.g. 5 flashes +
pause + 5 flashes = level 5.
6. To adjust the level of the water softener,
press the programme button. Each time you
press the programme button you go to the
next level.
7. Deactivate the appliance to confirm the set-
ting.
Filling the salt container
Caution! Only use dishwasher salt. Other
products can cause damage to the
appliance.
Water and salt can come out from the salt
container when you fill it. Risk of corrosion. To
prevent it, after you fill the salt container, start a
programme.
Water softener
adjustment
Manual Elec-
tronic
1) 9
2
1) 8
2
1) 7
2
1) 6
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1
www.zanussi.com