Makita XGC01 Manuel D'instruction page 8

Installing holder
013562
Hold the bottom of the holder and the holder joint, then
turn the holder clockwise. Tighten it firmly until it stops.
Make sure the holder is tightened firmly. Otherwise the
tool may be damaged.
To remove the holder, turn it counter clockwise.
NOTE:
You can rotate the holder in accordance with
•
required situations to facilitate the operation.
The short holder (300ml(18.3cu.in)) and big holder
•
(800ml(48.8cu.in)) are intended for the cartridges
only. Use only piston A with short holder
(300ml(18.3cu.in)). Use only piston D with big
holder (800ml(48.8cu.in)) Do not use them with
film type packs or direct filling. Also use
appropriate rod in accordance with the holder type.
Installing cartridge
NOTICE:
Make sure the piston A is attached to the rod. Do
•
not use other type of piston for cartridge.
Installing the cartridge into the short holder
(300ml(18.3cu.in))
013566
Pull the rod handle backwards slowly until it stops.
013567
1. Rod handle
1
Insert the cartridge into the holder as illustrated.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
Installing the cartridge into the long holder
(600ml(36.6cu.in) or big holder (800ml(48.8cu.in))
1
013572
Remove the holder cap from the holder.
Pull the rod handle backwards slowly until it stops.
1
013571
Insert the cartridge into the holder.
Attach the holder cap. Make sure it is tightened firmly.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, remove the holder cap, then
take out the cartridge.
NOTICE:
Always check the cartridge for puncture or
•
damage before installing. Do not use damaged
cartridge, otherwise the tool may be damaged.
When using a partially used cartridge, remove any
•
adhered material on the cartridge.
Installing film type pack
NOTICE:
Make sure the piston B is attached to the rod. Do
•
not use other type of piston for film type pack.
Film type pack can be installed in the long holder
•
(600ml(36.6cu.in)) only.
Remove the holder cap, the nozzle and the rubber ring
from the holder.
Pull the rod handle backwards slowly until it stops.
8
1. Holder cap
2. Rod handle
2
1. Holder cap