Publicité
Les langues disponibles
Les langues disponibles
For 100 mm (4") model
When installing the abrasive cut-off wheel:
16 mm (5/8")
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than
4mm (5/32")) 3. Abrasive cut-off wheel (4mm (5/32")
or thicker) 4. Inner flange
When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4mm
(5/32")) 3. Diamond wheel (4mm (5/32") or thicker)
4. Inner flange
For 115 mm (4 - 1/2") / 125 mm (5")
model
When installing the abrasive cut-off wheel:
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than
4mm (5/32")) 3. Abrasive cut-off wheel (4mm (5/32")
or thicker) 4. Inner flange
1
1
2
3
16 mm (5/8")
4
4
1
1
2
3
4
4
1
1
2
3
4
4
When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4mm
(5/32")) 3. Diamond wheel (4mm (5/32") or thicker)
4. Inner flange
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
► 1. Wire cup brush
Remove the battery cartridge from the tool and place it
upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush. It may lead to premature breakage.
15 ENGLISH
1
1
2
3
4
4
1
Publicité
