Disposing Of The Unit; Disposal Informations; Installation Requirements - John Bean T5745 Manuel D'utilisation

7.0

Disposing of the unit

When you decide to get rid of your unit, contact your
reseller for a quote or for the regulations on disposal which
apply to the unit.
7.1

Disposal Informations

For waste electrical and electronic equipment
At the time of disposal, at the end of the lifetime of this
equipment, you must:
1. NOT dispose of the equipment as municipal waste and
separate collection is mandatory.
2. Ask the retailer about collection points authorised for
regular disposal.
3. Stick to the standards for correct waste management,
to prevent potential effects on the environment and
human health.
This symbol indicates that separate collection of waste
electrical and electronic equipment is mandatory for
scrapping.
24
- EN
i

Installation requirements

THE INSTALLATION SHALL BE CARRIED OUT ONLY
BY QUALIFIED PERSONNEL AND WITHIN THE
SCOPE OF THE INSTRUCTIONS PROVIDED IN
THIS MANUAL.
Install the machine in a covered and dry area.
The installation of the machine requires a free space of
at least 270x270cm (106"x106") (Fig.i-1).
Make sure that from the operating position the user can
see all of the machine and the surrounding area.
The operator shall forbid, in such an area, the presence
of non authorized persons and of objects which may
create possible hazards.
The machine shall be installed on a horizontal floor
preferably even. Do not install the machine on a sinking
or irregular floor.
If the machine is installed on a raised floor, the floor
must have a capacity of at least 5000 N/m² (500kg/m²
or 110lbs sqft). The machine must be secured to the
x
floor through the holes provided in the cabinet.
Expansion screws 12x120mm shall be used.
Drill 12mm holes in the floor flush with the holes
provided in the cabinet.
Place the nogs into the holes drilled in the floor and
move the machine so that the holes of the cabinet are
flush with the holes in the floor. Tighten the screws at 70
Nm (51 ft lb).
x
i-1