Accessories Installation - John Bean T5745 Manuel D'utilisation

C
10
- EN
R
2.0-1
D
2.0-2

2.0 Accessories Installation

2.1 Installing the Kit: EAA0332G91A
- SLIDING JAW +4 INCH KIT
WARNING
BEFORE INSTALLATION, DISCONNECT THE
TIRE CHANGER FROM THE ELECTRICITY AND
COMPRESSED AIR SUPPLIES.
See Figure 2.0-1
A
1) Remove the standard jaws (R), present on the tire
changer turntable.
2) Insert the +4" jaws supplied in the kit on the turntable
B
sliding parts and align the side holes (A) with the holes
(B) in the sliding parts.
CAUTION: SECURE THE SLIDING PARTS WITH BOTH
SCREWS IN THE HOLES PREPARED.
See Figure 2.0-2
3) Insert the screws (C) in the side holes in the jaws, put
the washers (D) on the opposite side and secure with
the nuts (E).
NOTE: If the holes (B) in the sliding parts are blocked by
dirt, clean them by MANUALLY inserting an 8 mm diameter
spiral bit in them several times.
E
CAUTION: AFTER INSTALLATION, THE JAWS MUST
BE EQUIDISTANT FROM THE CENTRE OF THE
TURNTABLE.