Maintenance; Cleaning/Replacing Filters; Cleaning The Air Hoses; Wiring Diagram - CAPspray CS9960 Manuel De L'utilisateur

Maintenance

Use the following procedures to keep your HVLP spray system
running properly.
cleaning/Replacing the Filters
1. Remove each filter by grabbing them and pulling them
straight out of the filter cans on the turbine. This will not
damage the filters.
Cooling Air Filter
cS9960 wiring Diagram
Warning light
assembly
(P/N 0277193)
Air flow switch
(P/N 0277472)
English
Two-Stage Atomizing
Air Filter
(green side facing
the turbine)
Yellow
Turbine
(P/N 0277733)
2. Clean the filters. Either tap the filters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked
loose easily, soak the filters in soapy water or mineral
spirits. Allow the filters to dry completely before placing
them back in the turbine.
NOTE: Do not use highly flammable solvents, such as
lacquer thinner, to clean the filters.
3. Insert each filter back into its corresponding filter can.
NOTE: The two-stage, atomizing air filter must be placed
in the filter can labeled "2-Stage Filter" with the
green side facing the turbine.
After several cleanings, it may become necessary to replace the
filters. Refer to the parts list near the end of this manual for the
filter replacement kit part number.

cleaning the air hoses

1. Periodically wipe the outer surface of the air hose with a
damp cloth to keep clean.
IMPoRtant: Do not submerge into or flush the air hose
with water or any chemical.
IMPoRtant: Do not use methylethylketon (Mek),
naphtha, mineral spirits, paint thinner, xylol/xylene, or toluel/
toluene to clean the air hose. exposure over time could
cause damage to the hose.
ON/OFF switch
(P/N 0524315)
Blue
Black
Fuse holder (P/N 9851621)
15A Fuse (P/N 0275710)
4
White
Black
Green
© SprayTECH. All rights reserved.