EINHELL BT-PG 2800/1 Mode D'emploi D'origine page 16

Anleitung_BT_PG_2800_1_SPK7__ 28.02.14 07:30 Seite 16
GB
9. Troubleshooting
Fault
Engine does not start
Generator has too little or no
voltage
16
Cause
Automatic oil cut-out has not
responded
Spark plug fouled
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air filter dirty
Remedy
Check oil level, top up engine oil
Clean or replace spark plug
(electrode spacing 0.6 mm)
Refuel / have the petrol cock
checked
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the filter